Sample rate
2.5 – 4ml/min
Tubing materials
Silicone and Tygon®
Required desk space for Instrument
101*cm (H) x 45cm (W) x 35cm (D)
*For Safety reasons the Flame photometer requires 1m of unobstructed space above to allow dissipation of heat from the chimney.
Instrument size
Flash Photometer
51cm (H) x 33cm (W) x 35cm (D)
(20in x 13in x 14in)
Shipping
65cm (H) x 49cm (W) x 43cm (D)
(25in x 19in x 17in)
Weight
Flash Photometer – 10kg (22.1lbs)
Shipping – 18kg (39.7 lbs)*
*subject to vary based on accessories included
Power requirements
100V – 250V AC at 50 or 60Hz automatically selecting
Readout
5″ colour capacitive touch screen display
Optimal range
Single point calibration
Ca 1.0 – 100ppm
Multi Point Calibration (with dilution)
Ca 1.0 – 1000ppm
Reproducibility
<1% Coefficient of variability for 20 consecutive samples over ten minutes at concentrations of 100ppm or less. (After instrument stabilisation).
Limit of detection (LOD) and
limit of quantification (LOQ)
LOD LOQ
Ca – 0.3ppm Ca – 1ppm
Time to stability
Less than 15 seconds after sample is introduced into the flame.
Ions measured
Simultaneous measurement of model specific elements
Interfaces
USB
0-2.5 volt output (based on sample concentration linked to element of users choice)
Optional 4-20mA output in place of the above
Optional integrated printer
.csv and .pdf generated reports and files via FP-PC software
Recommended minimum warm up time based on ambient temperature
21ºC – 25 minutes
Fuel requirement
Propane, Butane or Natural Gas* regulated to 19Bar.
Flow rate of 0.4l/min
*with modifications. BWB Technologies recommends either Propane or Butane for optimum results.